HOW TO REMOVE CORROSION FROM STAINED GLASS

How to Remove Corrosion From Stained Glass

How to Remove Corrosion From Stained Glass

Blog Article

Corrosion on stained glass is commonly known as white mold. It seems over the direct or solder traces, leaving the stained glass piece spotted and unattractive. The corrosion or white mould is commonly the results of flux residue that was not completely eradicated.

Just one strategy employed to remove the corrosion is to wash the artwork glass piece with cleanser. This can get rid of the corrosion, however it may also induce scratches about the glass.

One of the simplest ways I have found for removing the corrosion is to employ baking soda. Baking soda is just not as abrasive as cleanser and is not going to scratch the glass.

You will need a little scrub brush or quite good metal wool. Initially dampen the scrub brush or steel wool with water. Then liberally sprinkle baking soda about the piece. Using the dampened scrub brush or steel wool, scrub the glass piece vertically, horizontally As well as in a circular movement.

The moment each of the corrosion has been scrubbed off, comprehensively rinse off the baking soda and dry the art glass piece. If your piece had a patina finish, you'll have to re-patina the piece. This will likely depend on exactly how much corrosion experienced accumulation around the piece.

Once the piece is completely dry, use a ending compound to protect and polish the artwork glass piece.

This process works incredibly effectively, though it will require time, perform and reapplying finishes. If you have a stained glass piece with corrosion, you actually do not have a preference. For potential reference, you can prevent corrosion from happening by properly taking away flux when constructing your upcoming piece.

The frequent explanation for corrosion is flux. Never ever leave flux on a bit for more than a few hrs. There are a variety of economic flux removers that you could use. You should definitely stick to manufacturers' Instructions.

I have found CJ's to get a good business flux remover. Following suppliers' directions, I liberally spray CJ's on just one side with the glass piece. Using a smooth scrub brush, I scrub the glass inside a round motion, then, rinse the piece with drinking water. Then, following precisely the same procedure, do the opposite side.

Employing baking soda and dish soap is an alternate for commercial flux removers. 1st, sprinkle the piece with baking soda, then utilize a small degree of dish soap to your piece. Having a smooth, damp scrub stained glass artist miami brush make use of a round motion to wash the piece. Rinse with water then do the other aspect.

Once the piece continues to be cleaned and rinsed with drinking water, pat the piece dry with a comfortable clean cloth and Enable it air dry. As soon as it is totally dry, patina is usually utilized. The final step is to apply ending compound to both sides.

Tend not to hurry the cleaning and ending. A good cleaning and ending will save you time, operate and expenditure later.

Report this page